1. Home / 
2. Loops / 
3. Preformed Saw-Cut Loop Kits

Vehicle Detection

Preformed Saw-Cut Loop Kits
with Sealant

This kit comes with one or two tubes of sealant, depending upon the size of the loop.

The Marsh Preformed Saw-Cut Loop Kit comes in a dozen different sizes, with sealant and your choice of four lead-in lengths.

Each loop consists of multiple turns of wire, bundled together. Also included is sealant to close up the channel created for the loop in the pavement.

The loops are ideally suited for vehicle detection in traffic control environments such as drive-thrus or parking lots when connected to the Marsh Products Loop Vehicle Detector. They are also compatible with other brands of vehicle detectors.

A concrete saw is used to cut a rectangular channel in the concrete or asphalt. The one-piece loop is set into the channel and topped with the sealant to keep the channel watertight.

The loop is intended to be used after pavement installation; if pavement has not been poured, the Marsh Products Direct Burial Preformed Loop is more cost-effective and easier to install.

Free ground shipping within the U.S.!